1/7/2024 0 Comments Emberglow gas fire![]() ![]() Combustion of hydrocarbon requires oxygen that must be pulled into the water heater from surrounding rooms. Usually if thermocouple is bad or installed incorrectly, the pilot goes out immediately after releasing the pilot knob during lighting.įirst thing is to clean water heater air intake and get more fresh air to the water heater and see if that solves problem. ![]() If ECO is tripped, then pilot will have no gas. If the pilot will light and stay lit, then ECO is not tripped, and thermocouple is probably good. Usually in the Fall, before you light the gas logs for the heating season. You just completed what's known as "Annual Maintenance." Which should be done at least annually. Take a moment to pat yourself on the back. Ease of the Control Knob and turn it to the ON position, Everything should not work as it was designed. Light the pilot as you normally would and once it lights, hold the Control Knob in for 1 minute. Now, reinstall the logs on the burner, the exact way they were before you removed them. You may see debris come out the other side. Place the tip of the straw nozzle just barley into that hole and give it a quick blast of air. About 2/3rds of the way down, you will see a hole in the side of the pilot. Tank the can of compressed air with the straw nozzle attached and blow out the pilot tip with a quick blast of air. After completing the vacuuming, look at the Pilot Assembly. Once you have the logs off the burner(s), use a vacuum that has a hose and brush attachment and vacuum the burner(s), the grate and any cobwebs you see in the firebox. Better yet, find your Owners Manual or take a picture of the setup, before you remove them. I should mention here, the logs have to go back in the exact same position and configuration that they were in, before you took them out. Remove the logs from the burner and carefully set them of to the side, out of the way. ![]() It can be cleaned with a can of compressed air with a straw nozzle (like you clean your computer with). The ODS is a safety device, that shuts the system down if it detects that there's not enough oxygen for safe combustion. From what you described it sounds like the Oxygen Depletion Sensor (ODS) may be partially clogged with dust, lint and/or pet hair. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |